Interface
-
JeePlug Pack
The JeePlug is a tiny board which can be used for prototyping and to “re-wire” connections between various headers and cables. There are 8 × 10 plated-through holes and pads, all the pads on the...€9.00 - €9.50
-
Plug Headers
The Plug Headers set contains ten 6-pin female 0.1" pin headers and ten 6-pin male 0.1" pin headers. These headers are used everywhere by JeeNodes and Plugs, as well as for the FTDI and PWR/SER/I2C connectors....€6.00
-
Plug Shield
The Plug Shield allows using I2C-based JeePlugs with any Arduino or compatible clone. It acts as interface between the hardware I2C port and the plugs. There is a level converter on board, as well as...€4.50 - €14.50
-
Right-Angled Plug Headers
This Plug Headers set contains ten 6-pin female 0.1" pin headers and ten 6-pin male 0.1" pin headers with the shorter legs conveniently pre-formed into a 90 degree bend. These headers are used everywhere by...€6.50
-
Stacking Headers
These stacking headers let you extend a board on top of existing headers, while allowing a next level to "stack" on top. Perfect for JeeNode ports (6-pin) and for the PSIX header (8-pin). They are...€6.00 - €6.50
