Jeeplugs
-
Plug Headers
The Plug Headers set contains ten 6-pin female 0.1" pin headers and ten 6-pin male 0.1" pin headers. These headers are used everywhere by JeeNodes and Plugs, as well as for the FTDI and PWR/SER/I2C connectors....€6.00
-
JeePlug Pack
The JeePlug is a tiny board which can be used for prototyping and to “re-wire” connections between various headers and cables. There are 8 × 10 plated-through holes and pads, all the pads on the...€9.00 - €9.50
-
Stacking Headers
These stacking headers let you extend a board on top of existing headers, while allowing a next level to "stack" on top. Perfect for JeeNode ports (6-pin) and for the PSIX header (8-pin). They are...€6.00 - €6.50
-
Proto Board
The Proto Board is a small add-on board which fits over all the connectors of a JeeNode (except the FTDI connector). The two “ends” of the board are slightly different to help identify the proper...€3.50 - €30.00
-
Flash Board
The Flash Board is a small PCB which sits on top of a JeeNode or SMD Kit, turning it into an ISP programmer for ATmega and ATtiny chips. The board includes an 128 Kbyte EEPROM,...€3.00 - €14.00
-
Right-Angled Plug Headers
This Plug Headers set contains ten 6-pin female 0.1" pin headers and ten 6-pin male 0.1" pin headers with the shorter legs conveniently pre-formed into a 90 degree bend. These headers are used everywhere by...€6.50
-
Utility Plug
The Utility Plug is a small board to interface any of the ports on a JeeNode to an RJ-12 jack. The kit includes the following extra components, to handle a variety of simple interfacing and...€3.50 - €14.00
