Skip to navigation.


JeeLink Classic

€27.50 - €32.50

Good news! The new batch is out of QA. No more queue. 

The JeeLink is a fully assembled and ready-to-use USB-type “stick” which plugs directly into a PC, Mac or USB hub. It contains Atmel’s ATmega328p AVR microprocessor, HopeRF’s RFM12B wireless radio module and a branded FT232R USB interface chip. The processor is pre-flashed with the OptiBoot loader (compatible with the Arduino Uno) and the RF12demo sketch. See the JeeNode description for more details.

 Attention FHEM users: This JeeLink version is supported by standard firmware
 Achtung FHEM Benützer: Diese JeeLink version wird durch die Standard Firmware unterstützt

Unlike JeeNodes, JeeLinks do not have any external ports to connect plugs or other components. The JeeLink comes in a clear plastic case and is intended as a wireless interface between other JeeNodes and a PC or Mac attached via USB.

The JeeLink v3 also has 16 Mbit of flash memory, which can be used to collect data. An on-board accurate 10 ppm crystal helps keep track of time, even when the attached computer is sleeping.

The on-board wireless radio module is the same as on JeeNodes. The standard JLink Classic 868 comes with the RFM12B ISM-band 868 MHz radio module (the band used across Europe).  Chose this variant unless you have a special compatibility requirement with equipment that uses a different ISM band.

For the 868 MHz ISM band, chose the JLink Classic 868 option.

For the 433 MHz ISM band, chose the JLink Classic 433 option.

For your own choice of radio module, chose the JeeLink NoRF option.

For the 915 MHz ISM band, refer to the Modern Device, USA shop (US$ prices).

The documentation and full design details are freely available.